Tran, Khanh VanWoracek , RobinKardjilov, NikolayMarkötter, HenningAbou-Ras, DanielPuplampu, StephenFörster, ChristianePenumadu , DayakarDahlberg, Carl F.O.Banhart, JohnManke, Ingo2023-02-222023-02-222022-08-080264-1275https://depositonce.tu-berlin.de/handle/11303/18230https://doi.org/10.14279/depositonce-17023Metastable austenitic stainless steel (304L) samples with a rectangular cross-section were plastically deformed in torsion during which they experienced multiaxial stresses that led to a complex martensitic phase distribution owing to the transformation induced plasticity effect. A three-dimensional characterization of the phase distributions in these cm-sized samples was carried out by wavelength-selective neutron tomography. It was found that quantitatively correct results are obtained as long as the samples do not exhibit any considerable preferential grain orientation. Optical microscopy, electron backscatter diffraction, and finite element modeling were used to verify and explain the results obtained by neutron tomography. Altogether, neutron tomography was shown to extend the range of microstructure characterization methods towards the meso- and macroscale.en600 Technik, Medizin, angewandte Wissenschaften::620 Ingenieurwissenschaften::620 Ingenieurwissenschaften und zugeordnete Tätigkeitenneutron tomographyphase distributionrectangular cross-sectiontorsiongeometrical effectArticle0264-1275